ProSys-5102
Box PC with Intel® Haswell i5-4300U
Importent note:
There is no „power-on-button“ on the device available:
Therefore the jumper
JP2
(AT/ATX Mode) has always set to „
AT-Mode
“!
According to this the
BIOS setting
for Power Mode is „
Power Off
“!
(Default settings ex factory)
BIOS Power Setting
Control Group Structure Name
BIOS Defaults
Possible Setting
ACPI Sleep State
S3 (Suspend to Ram)
Suspend Disabled - S3 (Suspend to Ram)
Restore AC Power LOSS
Power OFF
Power Off - Power On - Last State
Power Saving Mode
Disabled
Disabled - Enabled
Resume Event Control
Resume from S3 By PS/2
Keyboard
Disabled
Disabled - Enabled
Resume from S3 By PS/2 Mouse
Disabled
Disabled - Enabled
Resume By PCIE Device
Disabled
Disabled - Enabled
Resume By RingRTC Alarm
Disabled
Disabled - Enabled
Resume By RTC Alarm
Disabled
Disabled - Enabled
►
WatchDog Timer Configuration
JP3: Backlight Power Enable Selection for LVDS1 (Pitch 2.00mm)
(not used for Rail-PC-System !!)
Jumper
Setting
Status
1
1-3
Backlight
Enable
Voltage = +3.3V
3-5
Backlight
Enable
Voltage = +5V
2
2-4
Active High
4-6
Active Low
JP4: mPCIE Activity LED Indication (Pitch 2.54mm)
(not used for Rail-PC-System !!)
Pin
Description
1
LED+
2
LED-
JP5: USB Power Selection (Pitch 2.00mm)
Jumper
Status
1-2 Short
USB power will be cut off in S4 & S5
state.
2-3 Short
USB power will be cut off in Deep S5
state.
2
1
6
5
1
2
2
3
1