Elma Schmidbauer GmbH
14 Change parameters in Setup
Elmasonic Select
27 / 32
Empty units without drains (Elmasonic Select 30/40):
ü
Ultrasound operation has finished.
ü
The basket or insert has been removed.
ü
If using temperatures > 50 °C, allow the cleaning fluid to cool.
1. Disconnect the network cable.
2. Put the cover on.
3. Take hold of the unit firmly by the handles holding the cover in place and carry it carefully to a
sink.
4. Remove the cover.
5. Slowly tip the unit over the sink with one corner at the lowest point, and carefully pour out the
cleaning fluid.
ð
The tank is empty.
6. Clean the tank and disinfect it if necessary. See chapter Maintenance for information.
CAUTION! Never submerge the unit in water.
è
The unit is emptied, cleaned and, where necessary, disinfected.
14
Change parameters in Setup
IMPORTA
NT
If parameters marked with an asterisk (*) are changed, the saved programme will be
deleted. If necessary, make a note of the settings of the saved programmes before
changing them.
The unit is connected to a power supply.
The Parameter reference list is required for setting the parameter numbers and values.
The unit has been switched off.
Hold down the
Mode
button until the Setup menu is shown on the display.
First, press the
Plus/minus
buttons to set the parameter number, e.g., 01.
Then, press the
Plus/minus
buttons to change the parameter value, e.g., 00/01.
Set and change further parameters as required.
Press the
On/off
button to save the settings.
