90/112
WL31/WL31TG
12.0 SYSTEM CARE
12.1 ADDING OPTIONS OR ACCESSORIES
The optional devices and the accessories can also be installed a second time. In this case, before carrying out any type
of intervention, disconnect from the control panel main board both the batteries and the possible network power.
Afterwards follow the instructions contained in
3.2.1 ASSEMBLYOF OPTIONS AND ACCESSORIES.
12.2 DEVICES RESET
If it is necessary to annul the programming of a device to bring it back to its initial “not programmed” status, do as
follows:
12.2.1 IR30WL INFRARED DETECTOR
1. Open the detector by pressing the lower flap and lifting the cover.
2. Remove the battery, wait for at least 10 seconds and reinsert it, marinating the correct position of the poles.
3. The LED turns on constantly for about 4 seconds and then flashes for about 5 seconds. During this flashing
phase press the tamper for 5 seconds.
4. Release the tamper. The LED turns on constantly. Once the LED turns off, the detector
enters the “not
programmed” status. It is now possible to acquire the detector again.
12.2.2 IRA31WL PASSIVE INFRARED DETECTOR
1. Open the detector by pressing the lower flap and lifting the cover.
2. Remove the lens holder by operating the fixing tabs.
3. Remove the battery, wait for at least 10 seconds and reinsert it, keeping the correct position of the poles.
4. The LED turns on constantly for about 4 seconds and then flashes for about 5 seconds. During this flashing
phase press the tamper for 5 seconds.
5. Release the tamper. The LED turns on constantly. Once the LED turns off, the detector
enters the “not
programmed” status. It is now possible to acquire the detector again.
Tamper
LED
