MP500/4N-8-16 Programming
97
6.5
LIST OF VOCAL ANSWER MACHINE DTMF CONTROLS
Function
No.
menu
Accepted digits
Action
Vocal messages
Arm
Partitions
0
01 …16
followed by #
Arm all selected partitions
List of partitions indicated in the
command.
Arming result:
EXECUTED
NOT EXECUTED
#
Arm all configured partitions (total
arming)
Disarm partitions
1
01 …16
followed by #
Disarm all selected partitions
List of partitions indicated in the
command.
Disarming result:
DISARMED
#
Disarm all configured partitions (total
disarming)
Remote controls
Outputs
Commandable
2
“01”-“10”
Select output on which to apply the
remote control
Current status output message
Output command result
0 - 1
Output command
(0 = disarm, 1 = arm)
1
Pulsed output command
(1 = arm)
Environment
listening
from vocal keypads
3
1
– 8
(configured keypad
address)
Activate environmental listening on
selected vocal keypad.
No message
0
Switch between:
“environmental listening” and “Vocal
action”
Exclude
Include
Inputs
4
“001”-“128”
Select the logical input number to be
excluded/included (inputs which can
be excluded only)
Exclusion result
Inclusion result
1
Exclude input
0
Include input
GSM return call
(GSM only)
5
Goodbye message and end of
communication. The control panel will
call the number in modem mode if
type A return call is enabled and at
least one GSM modem number is
programmed.
System status
summary
9
List:
Partition status, stored events/notices,
faults present
Currently armed partition
messages
Stored event type/notice
messages
Present fault messages
Table 12 - List of DTMF commands
Examples
Key sequences
Result
0 #
Total system arming
1 0 2 0 5 0 7 #
Disarm partitions 2, 5 and 7
0 0 3 * 2 0 6 1 #
Arm partition 3 and activate commandable output 6
6.6
ENVIRONMENTAL LISTENING
You can listen to environmental noises in the place where the vocal keypad is installed on a telephone. If there are several vocal
keypads in the alarm system you can select which one to listen from each time.
The environmental listening function will remain active for approximately one minute and a half and will then be autom atically
interrupted. Press “
*
“ to interrupt listening in advance.
Furthermore, you can speak through the keypad speaker. Communication is one-way (you can either speak or listen), but you can
switch between speaking and listening whenever you want by pr
essing the “0” key on the telephone.
Summary of Contents for MP500/16
Page 139: ...MP500 4N 8 16 Programming 139 ...
