MEDEA Programming Manual
95
5.25
Zigbee Home Automation Modules
This can be used to view the ZigBee home automation modules in the system, divided into three tables:
Relay Modules, Shutter Modules and Temperature Control Devices.
It is accessed through the
PROGRAMMATION
→ Zigbee Peripheral → Zigbee Domotic Modules
menu.
Figure 96 - Zigbee home automation modules (relays and shutters)
The tables show:
•
NUMBER
: This is the sequential number of acquisition of the module.
•
PHYS.ADDRESS
: This is the physical address of the module.
•
DESCRIPTION
: This is the alphanumeric label used to identify the module more easily.
The following are also provided for the shutter modules:
•
APERTURE TIME
: This is the pre-set time for opening the shutter.
•
CLOSURE TIME
: This is the pre-set time for closing the shutter.
Double-click on the flasher line to open a pop-up window where it is possible to enter the identification
label of the module in
Description
. Use only alphabetic characters, including accented characters,
numbers, and spaces.
The following buttons appear under the tables:
•
Modify
: This can be used to configure the module highlighted in the table.
•
CSV
: This can be used to export the modules table to a
“.csv” file, which can be opened with a
spreadsheet.
•
: This can be used to export the modules table to a PDF file.
The
<
and
>
buttons at the bottom right are used to navigate between the pages of the modules, if their
number is greater than the number that can be displayed in a single screen.
