EL250RT
73
Repeated false alarms
Check that each of the individual optics is precisely aligned and repeat the procedure if
necessary, performing a full scan and ensuring there are no light sources that may affect
the calibration.
Make sure the power supply to the heaters is more than 20 Vac
in the terminal block
on the barrier.
Use shielded cable for the synchronization, connecting the sheath to the ground;
Check that the power supply cables are the right size;
If possible, increase the response time (see section 8).
DIRECTIVE 2012/19/EU OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL of 4 July 2012 on waste electrical
and electronic equipment (WEEE).
The crossed bin symbol on the appliance or on the packaging indicates that the product must be disposed of
separately from other waste at the end of its lifetime.
You must therefore dispose of the waste equipment by taking it to a designated collection point for the recycling of
waste electrical and electronic equipment. As an alternative to independent disposal, you can hand in the
equipment you wish to dispose of to the retailer when purchasing a new appliance of the same type.
Electronic products up to 25 cm in size can also be handed in for free disposal, with no purchase obligation, at electronics
stores with sales areas of over 400 m
2
.
Adequate separate collection for the future use of equipment assigned for recycling, treatment and environmentally friendly
disposal helps to prevent negative impacts on the environment and on human health, and promotes recycling and/or reuse
of the materials with which the equipment is made.
FRANÇAIS
The system activates
disqualification even
without any fog
Make sure the power supply to the heaters is more than 20 Vac
in the terminal block
on the barrier.
Check that each of the individual optics are precisely aligned and repeat the procedure if
necessary, performing a full scan and ensuring there are no light sources that may affect
the calibration;
For a more precise alignment, position one side of the column cover in front of the
lenses so as to have two surfaces interposed between TX and RX to double the beam
attenuation.
ELKRON
Tel. +39 011.3986700 - Fax +39 011.3986790
www.elkron.com
– mail to: [email protected]
ELKRON
is a commercial trademark of
URMET S.p.A.
Via Bologna, 188/C - 10154 Turin (TO) - Italy
www.urmet.com
MADE IN ITALY
