background image

INSTALLING SINK (CABINETS 30 INCHES WIDE AND WIDER)

ATTENTION INSTALLER:

1. Position template on countertop. Locate the 

    template front to rear,so that sink will not inter-

    fere with the cabinet.

2. Trace a line around the template. Cut along the

    inside of this line to provide opening.

3. Locate and drill the mounting holes (following

    the countertop manufacturer’s instructions) as 

    shown below.Holes should allow even spacing

    of mounting brackets around the sink.Type of 

    fasteners to be as recommended by countertop

    supplier.

4. Fasten mounting brackets (optional accessory-

    LKUCLIP8) to countertop loosely.

5. Using a good quality silicone caulk, apply a bead

    evenly all around the top of the sink flanges.
6. Position and align sink over the countertop 

    opening. Press silicone onto countertop.
7. Tighten fasteners until mounting brackets are 

    snug against sink.
8. Check alignment of sink to countertop opening.

9. Tighten down fasteners evenly. Be careful not to

    overtighten. Remove excess silicone.

1/2” COUNTERTOP REVEAL

COUNTERTOP

MOUNTING

BRACKET

APPROX.1/2"

SILICONE CAULK

(NOT FURNISHED)

SINK

1-1/8"

(NOT FURNISHED)

1) ELKAY RECOMMENDS THAT UNDERMOUNT SINKS SHOULD BE INSTALLED BY A PROFESSIONAL

    EXPERIENCED INSTALLER.
2) WARNING: THE ENCLOSED CUTOUT TEMPLATE WILL CREATE A COUNTERTOP OPENING THAT

    WILL EXPOSE APPROXIMATELY 1/2” OF SINK RIM LEDGE. IT IS RECOMMENDED THAT YOU DIS-

    CUSS THIS WITH YOUR CUSTOMER AND AGREE THAT THIS FINISHED APPEARANCE IS THE 

    DESIRED EFFECT. ELKAY IS NOT RESPONSIBLE FOR IMPROPER SINK OR COUNTERTOP INSTAL-

    LATIONS. DUE TO THE AESTHETIC QUALITIES OF THE CONVERGING BOWL RADII, THE TEMPLATE

    FURNISHED WITH EACH SINK PROVIDES THE ONLY OPENING RECOMMENDED FOR INSTALLATION

    OF ELKAY UNDERMOUNT SINKS. SEE ILLUSTRATION BELOW.

3) ELKAY UNDERMOUNT SINKS SHOULD ONLY BE FASTENED TO A SOLID SURFACE COUNTERTOP

    (I.E. GRANITE/CORIAN /SILESTONE   ). 

®

®

4) ELKAY IS NOT RESPONSIBLE FOR SINK OR COUNTERTOP IF DAMAGED DURING INSTALLATION. 
5) METAL EDGES MAY BE SHARP -  USE CAUTION WHEN HANDLING. 
6) FOLLOW ALL LOCAL PLUMBING AND BUILDING CODES. 
7) INSPECT SINK FOR DAMGAGE PRIOR TO BEGINING INSTALLATION. 

Installation Instructions

ELUH2317 Series Undermount Stainless Steel Sinks

with 1/2" Reveal Countertop Installation

Reviews: