Eliwell FREE Panel EVP 3300/C, Installation Manual

Page: 16 / 39

5 USER INTERFACE
The interface, comprising the front cover of the controller, allows you to perform all operations needed to use the device.
EVP
5.1 Keys and LEDs
The LEDs can be programmed from the IEC application.
The keys can be programmed from the IEC application. By default , the device displays a short menu containing the
following default settings.
Key Key
Press once
(press and release)
1 UP

Scroll up
 Return to previous page (e.g. 2/10

3/10)

Increase / modify a value
 Go to the next label
2 OK

Scroll down
 Move to next level/menu (open folder , subfolder, parameter,
value)
 Enter/exit edit mode

Confirm operation
3
>
 Moves cursor to right in Edit Mode
4 DOWN
 Scroll down
 Move to the next page (e.g. 1/10

2/10)
 Decrease / modify a value
 Go to previous label
5

Exit

Exit menu page / go back to previous menu
 Move cursor to left in Edit Mode

(press and hold) Exit Edit Mode without saving any changes
EVP is factory configured with a default DIAGNOSTICS (DIA) menu that appears when the instrument is powered on.
After uploading of an IEC application and/or a HMI menu from FREE Studio, the main display consists of the application
menu created with FREE Studio Interface.
In which case, to open the DIAGNOSTICS menu proceed as follows:
Key combination
Prolonged press (press and hold for
about 3 seconds)
DOWN
4+5

Exit
Open DIAGNOSTICS menu
To return to the IEC application menu open the ‘ HMI Management ’ page, select

and press the OK key
See Remote Interface paragraph
DIA Menu
<IMG INFO>