ELICA EVR630SS, Use, Care And Installation Manual

Page: 13 / 64

13
Mounting the hood
WARNING: 2 people are required to lift and position the
hood onto the mounting screws.
• Place the template on the wall along the horizontal line,
make sure the template is leveled and centered with the
centerline.
• Mark “upper” screw holes locations in the wall.
•
IMPORTANT. Check to be sure that hole locations are
leveled and correctly centered by the vertical centerline.
• Drive “upper” wood screws by hand. Leave ¼ “ of
distance between the screw head and the wall.
• Remove the grease filter and mount the hood onto the
“upper” screws.
• Mark “lower” wood screw holes locations in the wall
using a pencil.
• Remove the hood.
• Drive “lower” wood screws, by hand. Remove screws.
• Mount the hood onto the “upper” screws.
• Drive and tighten the “upper” wood screws, by hand.
• Drive and tighten the “lower” wood screws, by hand.
Air deflector installation
• Assemble the air deflector with the duct cover bracket
with 4 assembly screws provided as shown.
• Measure from the bottom of the air deflector to the
bottom of the hood outlet, as shown.
• Cut the duct at the measured size.
• Uninstall the air deflector removing the 4 assembly
screws.
• Slip the duct onto the bottom of the deflector.
• Place the assembled deflector and duct over the exhaust
outlet from the hood.
• Assemble the air deflector to the duct cover bracket with
4 assembly screws provided as shown.