Operation Modes
- 22 -
Figure 17: Numeric and alphanumeric input field
10.3.1
Cycle Counter in Program Mode
In program mode, the controller has a cycle counter with 3 different modes:
Cycle counter disabled
Upwards counter: If the program has been executed, it starts again from the beginning and the
cycle counter is incremented.
Downwards counter: If the program has been executed, the cycle counter is decremented and the
program jumps back to the beginning. If the cycle counter reaches the value 0, the controller is
stopped. No further cut can be executed.
The mode can be selected and a value preselected by pressing the cycle counter button.
The mode is toggled by pressing the cycle counter mode button again:
(Disabled)
(Upwards)
(Downwards)
Disabled […]
Enter
Enter
Clear entry
Escape / Back
Change sign
Switch between
upper and lower
case letters
Escape / Back
Clear entry
Clear last entry
Summary of Contents for P40T-002 Series
Page 49: ...Service Mode Parameter Level 49 11 11Sub Menu Times System Figure 33 System Times ...
Page 83: ... 83 Notes ...
Page 84: ... 84 Notes ...
Page 85: ... 85 Notes ...
