Type Designation
- 39 -
NOTE
When ordering, please use the ordering code (Type Designation) described on the previous
page. Options that are not required are filled in with „-„.
12.1
Example of available Variants
Table 30: Example of available variants
Order description
Description
EMAX00015010SB0---------------
EMAX with binary SSI interface, 25 bit and 1.5 m cable
EMAX0001510SB0-----M8F0------
EMAX with binary SSI interface, 25 bit, 1.5 m cable and
M16 plug connector (female) for PNO1
EMAX00015010SG0-----------T2N5 EMAX with SSI-Gray Interface, 25 Bit, 1.5 m cable, TTL-square-wave
signal, 2,5 µm Resolution
EMAL00015010CA0125k0---------- EMAL for measuring lengths up to 20 m, according to ELGO standard,
with CANopen interface, 1.5 m cable, 125 kbit/s and device address: 0
12.2
Accessories
Table 31: Accessories
Order Designation
Description
AB20-50-20-2-R-11
Magnetic tape for EMAX
AB20-50-20-2-R-12
Magnetic tape for EMAL
Magnetic tape end cap set (20 mm)
2 end caps (20 mm) and two M3 screws; additional fixation in the
radial and linear range and protection of the magnetic tape ends
FS-1000, FS1500 or FS2000
Guide rail for magnetic tape (length 1.0, 1.5 or max. 2.0 m).
For larger distances several guide rails can be rowed together.
FW2080
Guide carriage for EMAX (only versions with connector housing)
DKA-00-Q7F0-050*-XXXX-06-N-N-N
)* 050 = standard length 5 m
020 = 2 m
100 = 10 m (others on request)
Standard signal cable for versions with connector on housing:
(sensor side 7-pin M9) (customer side 6-wire)
DKA-00-Q7F0-050*-R4MA-04-N-N-N
)* 050 = standard length 5 m
020 = 2 m
100 = 10 m (others on request)
IO-Link signal cable for versions with connector on housing:
(sensor side 7-pin M9) (customer side 4-pin M12)
PNO1
SSI/ PROFIBUS Converter
710000130
PSF 30 x 30 mm pole finder foil for magnetic tapes
1 =
+
24
VD
C
2 =
N
.C
.
3 =
0
V /
G
ND
4 =
C
/
Q
M12
-4
1
3
2
4
M9-
7
1 =
+
24
VD
C
2 =
N
.C
.
3 =
0
V /
G
ND
4 =
C
/
Q
