ELGO Electronic PMIX Series, Operating Manual, Page: 8 / 20

Product Features
- 8 -
3.4 Measuring Systems and Resolutions
The PMIX resolution is depending on the selected basis measuring system (see type designation

8).
The following table will show all available versions.
Table 1: Measuring Systems and Resolutions
Measuring System Resolution Magnetic tape pole pitch
LMIX 0.1 mm at single edge triggering
0.025 mm at four edge triggering 5 mm
EMIX 0.01 mm at four edge triggering 2 mm
EMIX23 0.001 mm at four edge triggering 2 mm
IZ14E/15E/16E/17E 0.01 mm / 0.1 mm (einstellbar via Parameter) 2.5 mm
3.5 Power Supply Voltages and Output Levels
For the LMIX and EMIX based versions, the following combinations are available:
1. Order suffix 00* = 10 … 30 VDC power supply / output levels 10 … 30 V-HTL
2. Order suffix 01* = 10 … 30 VDC power supply / output levels 5 V-TTL line driver
3. Order suffix 11* = 5 VDC power supply / output levels 5 V-TTL line driver
* Order suffix (see type designation

8)
Note: To reach the largest possible interference distance it is recommended to supply the
PMIX linear encoder with 10 … 30 VDC and to select the A/B signals 5 V-TTL-compatible
with differential evaluation.
3.6 Pulse diagram
Figure 2: Output pulse diagram
B
B‘
Z
Z‘
A
A‘
Channel A and B are
phase shifted by 90°
The index pulse output is
periodically every 2 mm (EMIX)
resp. 5 mm (LMIX)