ELGO Electronic HWD15 Series, Operating Manual, Page: 12 / 24

Installation and First Start-Up
- 12 -
6.4 Display Overview
The following display symbols resp. segments of the LCD display are used in this software version:
Figure 6
: Display Overview
1
Segments for numeric and text display (including signs, decimal points, fraction display)
2
Symbols for measurement units and display mode
3
Icons for active tool-offsets 1 ... 3
4
Battery status icons (3 elements)
Supplementary information:
For different applications the symbol for the measurement unit can be changed via parameter P02, e.g. the
degree symbol „°“ for angle measurements (see section

6.7).
The normalization of the display value must be carried out manually using the multiplication factor P08 and
the decimal place P03 (see section

6.7).
In the Inch mode an additional fraction display is available (see section

6.9.5).
If none of the 3 battery status icons is displayed, a battery change (see chapter

5) is required.
2
3
4
1