Elgas DATCOM, Operating Instructions Manual

Page: 53 / 228

5
Installation and Commissioning
51
Fig. 9 Mounting of the ELCOR convertor on the mounting plate
3. Attach a 6 mm connection pressure tube to the pressure sensor in the bottom of the
cabinet to connect the 3-way valve. To attach the tube to the pressure sensor, use a
cutting ring with M12x1.5 ERMETO nut.
4. Screw the holder under the three-way tap
9
onto the mounting plate
4
into the
prepared position with two M4x10
8
screws. Attach a three-way tap
5
to this metal
holder using 2 screws M4x40 ISO 7045
7
Check that the pins and the position of the
three-way tap control lever are correctly oriented before installation. Connect the free end
of the connection tube to the three-way valve outlet (for more details, refer to Section
5.4.4).
5. Check the tightness of the connections.
Mounting plate
designation
Designed
for device
Size [mm] Note
KP 107 85 ELCOR 250 x 250 For mounting without 3-way valve
KP 107 86 ELCOR 250 x 350 Allows for mounting 1 pc of 3-way valve
KP 107 87 ELCOR For mounting on turbine gas meter ELGAS
(see Fig. 13)
KP 107 88 ELCOR For pipe flange mounting with 3-way valve
mounting option (see Fig. 12)
KP 108 85 ELCOR plus 300 x 250 For mounting without 3-way valve
KP 108 88 ELCOR plus 300 x 400 Allows for mounting up to 2 pcs of 3-way
valve (for dual channel corrector)
Table 1 Mounting plates supplied