Elgas DATCOM, Operating Instructions Manual

Page: 107 / 228

6
Operating the Device
105
E12 - not used -
E13 battery disconnected 19 Battery is disconnected
E14 P1 under limit 32
Pressure range exceeded (1st channel)
E15 P1 above limit 33
E16 P1 error 36 Pressure transducer error
E17 T1 under limit 37
Temperature range exceeded (1st channel)
E18 T1 T1 above limit 38
E19 T1 error 41 Temperature transducer error
E20 P2 under limit 48
Pressure range exceeded (2nd channel)
E21 P2 above limit 49
E22 P2 error 52 Pressure transducer error
E23 T2 under limit 53
Temperature range exceeded (2st channel)
E24 T2 T2 above limit 54
E25 T2 error 57 Temperature transducer error
E26 time synch 4 RTC synchronization error, adjustment by > 2 h was
required.
E27 mod.bat.capacity 15 The modem battery is discharged
E28 encoder error 20 Encoder error (SCR or NAMUR)
E29 CRC metrolog. 22 CRC error of metrological part of the FW
E30 CRC tables 23 CRC error in password or encryption key table
E31 FRAM error 26 FRAM memory error
E32 FLASH error 27 FLASH memory error
E33 bar sensor error 46 Integrated barometric transducer error
Table 14 List of events - error messages (Err indication)
Displayed Message bit Description
W0 transd. warning 11 Warning alert on one of connected transducers (internal
modules SCR, NAMUR, EXT1, SRM or other). Details can
be found by reading the parameters of the corrector.
W1 - not used -
W2 battery 13 Memory error in battery pack.
W3 overcurrent 14 Current overload occurred
W4 - not used -
W5 network failure 16 Mains power supply failure
W6 21 - not used -
W7 tamper contact 1 24 Tamper contact 1 active.
W8 tamper contact 2 25 Tamper contact 2 active.
W9 P1 min. limit 34
Pressure user limits exceeded (1
st
channel)
W10 P1 max. limit 35
W11 T1 T1 min. limit 39 Temperature user limits exceeded (1
st
channel)
W12 T1 T1 max. limit 40
W13 Q1 Q1 min. limit 42 Flow rate at measurement conditions user limits exceeded