Elgar Sorensen DCS 3kW Series, Operation Manual, Page: 10 / 81

Sorensen DCS Series 3kW Supplies Contents
SECTION 7 DRAWINGS AND SCHEMATICS.......................................7-1
SECTION 8 APPLICATION NOTES .....................................................8-1
8.1 Battery Charging.............................................................................................. 8-1
LIST OF FIGURES
Figure 1-1 DCS Series (3kW) Supply Front Panel Controls and Indicators ............... 1-4
Figure 1-2 DCS Series (3kW) Supply Rear Panel Connectors and Terminals
(including optional internal GPIB Interface) .............................................. 1-5
Figure 2-1 AC Connector and Contacts ..................................................................... 2-5
Figure 2-2 Wire Preparation ....................................................................................... 2-5
Figure 2-3 Contact Orientation ................................................................................... 2-6
Figure 2-4 AC Wire Locations .................................................................................... 2-6
Figure 2-5 Strain Relief, as Supplied.......................................................................... 2-7
Figure 2-6 Strain Relief Assembly .............................................................................. 2-7
Figure 2-7 Connector J3 Default Configuration .......................................................... 2-8
Figure 2-8 Maximum Load Wire Length ................................................................... 2-11
Figure 2-9 Single Load with Local Sensing (Default) ............................................... 2-12
Figure 2-10 Single Load with Remote Sensing ........................................................ 2-12
Figure 2-11 Multiple Loads with Local Sensing ........................................................ 2-13
Figure 2-12 Multiple Loads with Remote Sensing .................................................... 2-13
Figure 3-1 Operating Modes....................................................................................... 3-2
Figure 3-2 Local Mode Default Configuration............................................................. 3-3
Figure 3-3 Connecting Remote Sense Lines.............................................................. 3-5
Figure 4-1 Connector J3 Pin Descriptions (for Remote Programming,
Remote Monitoring, and Sense Connections) .......................................... 4-3
Figure 4-2 Internal Jumpers and Switch (Default Settings Shown) ............................ 4-4
Figure 4-3 Programming Output Voltage and Current Limit Using the
REM/LOC Switch...................................................................................... 4-8
Figure 4-4 Programming Output Voltage with a 0-5 Vdc Source ............................... 4-9
Figure 4-5 Programming Output Voltage with a 0-10 Vdc Source ............................. 4-9
Operation Manual vii