27/01/22
User Manual TPS/T 10-90kVA 62000560_09_
22
value of the output voltage is equal to the set-up voltage and an error signal appears (see at
voltage alarms).
3.7.2.
Output type
Both single-phase and three-phase outputs are available.
To change the output type, proceed in the following way:
1.
Press the relative switch on the central part of the front panel.
2.
Wait until the output power is switched off and the type of output is changed.
3.
Wait about 15 seconds and the output is switched on again and the Volts display visualizes
zero voltage (0.0);
4.
Set the desired voltage value.
3.7.3.
Continuous or INRUSH mode
Using the "Inrush" switch you can select the operation of the machine, in particular you can
change the current limits as shown in the tables.
When the LED on the switch INRUSH is lit, the machine is on Inrush mode and the TPS/T can gives
three times the rated current.
When the LED on the switch INRUSH is off, the output continuously current is higher.
This button is disabled if the machine has not the INRUSH capabilities.
3.8.
ALARMS