Other Accessories Included:
• 1 “
½
AA” Lithium Battery
(included in the unit)
IMPORTANT PRODUCT NOTICES AND SAFETY
INSTRUCTIONS
• Although the readings from this device are for reference only, the
Mayo Clinic (http://mayoclinic.com/health/hypoxemia/MY00219)
suggests that normal readings are between 95 to 100% under most
circumstances. Readings under 90% are considered low.
• This is a home healthcare product only and is solely intended for
sports and recreational use. It is not intended to serve as a substitute
for the advice of a physician or medical professional.
• The readings from this pulse oximeter are for reference only. Consult
a healthcare professional for interpretation of your pulse oximeter
measurements. Contact a physician if you have or suspect any
medical problem. Do not change your medications without the advice
of your physician or healthcare professional.
• The pulse display is not suitable for checking the frequency of
pacemakers.
• Use the pulse oximeter only for its intended use.
• Please keep this device away from children. Small parts such as
battery and battery door could be hazardous if swallowed.
• The lanyard could cause strangulation in conditions when twisted
around the neck.
• This pulse oximeter should not be used where alarms are required
when taking measurements.
• For greatest accuracy, wait 10 minutes after exercising, bathing, eating,
drinking beverages with alcohol or caffeine, or smoking to measure
blood oxygen level.
• Use only 3.6V “
½
AA” Lithium battery for power supply.
• Do not use cellular phones or other radio frequency producing devices
near the working device as it may interfere with proper operation of
the pulse oximeter.
• Not for use by or on persons under the age of 18 years old.
CARE, MAINTENANCE & CLEANING
• Use a cotton swab with isopropyl alcohol solution (70%) to clean the
inside of the finger sleeve or the outside of the unit.
• DO NOT use any other liquid or sprays on the oximeter for
cleaning purposes.
• Under normal usage conditions, this device does not require
calibration or technical maintenance other than infrequent
replacement of the battery.
• Leaky batteries can damage the unit. Remove the battery when
the unit will not be used for a long time.
• This product should only be used on the fingers.
• DO NOT disassemble this device. If in need of repair, refer to the
warranty section of this manual.
• DO NOT use the product if the finger sleeve changes color or is
no longer able to secure on finger.
• DO NOT subject this device to extreme shocks (do not drop on
floor).
• DO NOT drop or insert any object into any opening.
• DO NOT immerse the unit in water as this will result in damage to
the unit.
• DO NOT subject this device to extreme temperatures, humidity,
moisture, or direct sunlight. Protect from dust.
• If the unit is stored near freezing, allow it to acclimate to room
temperature before use.
• This monitor may not meet its performance specifications if stored
or used outside of these temperature and humidity ranges:
TROUBLESHOOTING
If any abnormality arises during use, please check the following points:
ABOUT PULSE OXIMETERS
This pulse oximeter uses patented technology, which utilizes
revolutionary optical sensor technology to measure both blood
oxygen saturation (SpO
2
%) levels and pulse rate. By placing the
finger into the sleeve and one-touch of a button, this device will
send both red and infrared lights into the skin to collect data and
display your blood oxygen and pulse rate.
NAME/FUNCTION OF EACH PART
Storage Environment
Temperature
-4
°
F – 158
°
F
(-20
°
C – 70
°
C)
Humidity: Less than 95%
non-condensing
Operation Environment
Temperature
39
°
F – 107
°
F
(4
°
C – 42
°
C)
Humidity: Less than 95%
non-condensing
DISPLAY EXPLANATIONS
SYMPTOMS
POSSIBLE
CAUSES
CORRECTION
Pulse Rate or
SpO
2
is not
appearing.
Position of the
finger is not
correct.
Reposition the finger into the
correct position and measure
again.
The pulse
oximeter will
not power on.
Battery has run
down.
Replace the battery with a single
3.6V “
½
AA” Lithium battery.
Screen
orientation is
upside down.
Viewing angle
needs to be
adjusted.
Press the Multi-directional
button
for up to 2 seconds
and the screen will rotate 180
°
.
REPLACING BATTERY
1. The battery compartment is located
on the top of the unit. Remove battery
cover by pressing down and sliding the
battery cover off. (fig. 1)
2. Install or replace the battery according
to the polarity indicator located inside
the compartment. Use only 3.6V
“
½
AA” sized Lithium batteries. (fig. 2)
3. Replace the battery cover by inserting it
back into place. (fig. 3)
Replace the batteries if:
• The weak battery symbol appears on
the display.
• Nothing appears on the display after
the finger is inserted into the sleeve and
the button is pressed.
Note: Batteries are hazardous waste. Do
not dispose of them together with the
household garbage.
Fig. 2
Fig. 3
Fig. 1
MEASUREMENT PROCEDURE
If you are using this pulse oximeter for the
first time, please remove the protective film
from the screen and remove the pull tab
from the battery door.
1. Hold the pulse oximeter so that the
picture of the finger nail on the finger
sleeve is facing up.
2. Gently place any finger into the finger
sleeve as shown in the diagram
(fig. A). Slightly press on the sides of the
finger sleeve to ease the finger inside.
3. Turn the hand over so that the LCD screen
is now facing you and your finger is
pointed up (fig. B).
4. Push the Multi-directional button
to
initiate readings (fig. C).
5. Continue to vertically hold the pulse
oximeter to enable readings
6. To change the direction of the LCD
screen display by 180
°
, press the Multi-
directional button
for up to two (2)
seconds.
Note:
• Signal strength should be greater than one
bar to indicate a proper reading
(fig. D).
• In the event of weak signal strength, please
switch fingers and/or hand and try again.
• For greatest accuracy, limit hand motion
during measurement.
• When the finger is removed, the pulse
oximeter will turn off after 10 seconds.
Fig. A
Fig.B
Fig.C
Fig.D
PRODUCT SPECIFICATIONS
Effective Measuring Range
Saturation
70 to 99%
Pulse Rate
40 to 250 bpm
Resolution
1 digit
Accuracy
Saturation (70%-99%)
±2% or ±2 digits
Pulse Rate
±3% or ±3 digits
Display
Saturation
2 characters
Pulse Rate
3 characters
Signal Indications:
Flashing Heart Icon, Sensor ‘Off’ and
Signal intensity strength, battery
indication - near empty
Power Requirements
3.6V “
½
AA” size Lithium battery
Battery life
up to 300 Hours
Type BF Applied Part
Spot Measurement No alarms
SpO2
Deluxe Pulse Oximeter
Note: When changing the orientation of the screen, the pulse rate
will be shown on the top near the blinking Pulse Rate Icon, and the
blood oxygen level will be shown on the bottom of the LCD display.
Finger Sleeve
Multi-directional
Button
LCD Display
Battery
Compartment
Signal Strength
Indicator
Pulse Rate
Blood Oxygen
Level
SpO
2
Sensor Off Indicator: Appears when the finger has
been removed from the finger sleeve.
Weak Battery Symbol: Flashes when battery should
be replaced.
Pulse Rate: Shows the pulse rate per minute.
SpO
2
SpO
2
Indicator: Shows the blood oxygen saturation
level value on a scale of 70 to 99%.
Calculating: Device is calculating blood oxygen
saturataion (SpO
2
%).
/
START
STOP
3
/
START
STOP
3
• Storage Pouch
• Lanyard
eCheck - elepho
