Elenco Electronics M-1006K, Assembly And Instruction Manual, Page: 7 / 20

-6-
Close-up view of the
transistor socket and
PC board.
Solder Side
Solder Side
Figure D
Tab
Input Sockets
Shunt Wire
Red Wire
Black Wire
Solder
Battery Snap
Transistor
Socket
Fuse Clips
Remove the clear protective film from the front of the LCD (Note:
DO NOT remove the silver backing). Place the LCD, zebra frame,
and zebras into the top case as shown in Figure E. Be sure that
the LCD tab is in the same direction as shown in the figure.
Cut open the plastic envelope containing the grease and put a
small amount of grease in each spring hole of the selector knob
as shown in Figure F. Then, insert a 1/4” spring into each hole as
shown in the figure.
Clear Protective Film
Figure F
Spring Holes
1/4” Springs
Figure E
LCD
Zebras
Tab
Zebra Frame
Top Case