12. FX TRACK PARAMETERS
61
12.3.8 DRIVE
Drive sets the amount of analog drive that is added to the audio routed through the FX track. Yes, it goes
to 11!
12.4 FLTR PAGE 1
On FILTER page 1, you will find the parameters that control the analog multimode filter and its associated
envelope.
Press
[FLTR]
to access this parameter page.
12.4.1 ATK
Attack Time sets the length of the attack phase of the filter envelope.
12.4.2 DEC
Decay Time sets the length of the decay phase of the filter envelope.
12.4.3 SUS
Sustain Level sets the sustain level of the filter envelope.
12.4.4 REL
Release Time sets the length of the release phase of the filter envelope.
12.4.5 FREQ
Frequency sets the cutoff frequency of the multimode filter.
12.4.6 RESO
Resonance sets the resonance behavior of the filter. Resonance introduces a peak in the spectrum at
the cutoff frequency.
12.4.7 TYPE
Filter Type selects the type of filter. (4-pole Lowpass, 2-pole Lowpass, Bandpass, Highpass, Notch, Dou-
ble-Notch, Lowpass-Notch, OFF)
12.4.8 ENV
Env. Depth sets the amount of cutoff frequency modulation from the filter envelope. The knob is bipolar,
both negative and positive modulation depths are available.
