8. PATTERNS AND SOUNDS
31
PITCH BEND
Opens a menu where you can assign up to four PARAMETER page parameters to the pitch bend. The
pitch bend from incoming MIDI sent to the Syntakt from external devices affects the assigned param-
eters. Press
[YES]
to open the menu.
You can select parameters from the SYN, FLTR, AMP, and LFO PARAMETER pages. Turn the
DATA
ENTRY
knobs
A
–
D
to select the track parameters that you wish to assign. Press
[YES]
to confirm the
selection. Then use
DATA ENTRY
knobs
E
–
H
to set the modulation depth of the four track parame-
ters. The depth is an offset of the original track parameter value.
Turn
LEVEL/DATA
to test your settings.
VELOCITY MOD
Opens a menu where you can assign up to four PARAMETER page parameters to the velocity pa-
rameter. Both the
VEL
parameter on the TRIG menu and the velocity of incoming MIDI notes sent to
the Syntakt from external devices affects the assigned parameters. Press
[YES]
to open the menu.
Selecting parameters and setting modulation depth works in the same way as for
PITCH BEND
.
Turn
LEVEL/DATA
to test your settings.
MOD WHEEL
Opens a menu where you can assign up to four PARAMETER page parameters to the MIDI mod wheel
command (CC #1). Press
[YES]
to open the menu. Selecting parameters and setting modulation depth
works in the same way as for
PITCH BEND
.
Turn
LEVEL/DATA
to test your settings.
BREATH CONTROLLER
Opens a menu where you can assign up to four PARAMETER page parameters to the MIDI breath
controller command (CC #2). Press
[YES]
to open the menu. Selecting parameters and setting modu-
lation depth works in the same way as for
PITCH BEND
.
Turn
LEVEL/DATA
to test your settings.
AFTERTOUCH
Opens a menu where you can assign up to four PARAMETER page parameters to the MIDI aftertouch
command. Press
[YES]
to open the menu. Selecting parameters and setting modulation depth works
in the same way as for
PITCH BEND
.
Turn
LEVEL/DATA
to test your settings.
8.6.2 SOUND BROWSER
The SOUND BROWSER is used to preview and load sounds. You can also press
[FUNC]
+
LEVEL/DATA
to open the SOUND BROWSER. This menu will show a list of all sounds in the +Drive sound library that
can be loaded to the active track. Scroll the list by turning the
LEVEL/DATA
knob or by pressing
[UP]
/
[DOWN]
. Press
[TRIG 9–16]
to select sound bank A–H. Press
[FUNC]
+
[YES]
to preview the sound be-
fore you load it to the track. You can also use KEYBOARD mode, or an external MIDI controller, sending
