3. PANEL LAYOUT AND CONNECTORS
12
3.2 REAR CONNECTORS
1
2
3
4
5
6
1.
DC IN,
Input for power supply. Use the included PSU-4 power adapter, connected to a power outlet.
2.
USB,
For connecting the unit to a computer. Use the included USB A to Micro B connector cable to
connect to a computer host.
3.
MIDI OUT/THRU,
Use the included 3.5 mm (Tip/Ring/Sleeve) to female 5 pin DIN cable to connect – via
a standard MIDI cable – to MIDI IN of an external MIDI device or to another MIDI device in the chain.
4.
MIDI IN,
MIDI data input. Use the included 3.5 mm (Tip/Ring/Sleeve) to female 5 pin DIN cable to con-
nect – via a standard MIDI cable – to MIDI Out of an external MIDI device.
5.
MAIN OUT R/L,
Main audio outputs. Use either 1/4” mono phone plug (unbalanced connection) or
1/4” (Tip/Ring/Sleeve) phone plug (balanced connection).
6.
HEADPHONES,
Audio output for stereo headphones. Use 1/4” (Tip/Ring/Sleeve) phone plug.
3.3 SIDE CONNECTOR
1
1.
BATTERY DC In,
Input for accessory battery power supply.
3.4 SETTING UP AND STARTING THE MODEL:CYCLES
Make sure you place the Model:Cycles on a stable support, such as a sturdy table, with sufficient space for
the cables. Make sure to switch off all devices before you connect the Model:Cycles to other devices.
1. Plug the supplied DC adapter to a power outlet and connect the small plug to DC IN on the
Model:Cycles.
2. Connect MAIN OUT R/L from the Model:Cycles to your mixer/amplifier or connect your headphones to
the Model:Cycles HEADPHONES jack.
3. To control the Model:Cycles from a computer, connect a USB cable between the computer and the USB
connector of the Model:Cycles.
4. If you want to use MIDI to control the Model:Cycles, connect the MIDI OUT port of the device you wish
to send data from to the MIDI IN port of the Model:Cycles. If the MIDI OUT/THRU port is set to function
as THRU, it duplicates the data arriving at the MIDI IN port, so it can be used for chaining MIDI units
together. Connect the MIDI OUT/THRU port of the Model:Cycles to the MIDI IN port of the of the device
you want to control if you want to use Model:Cycles to control other devices. (Set the port to function as
OUT.)
5. Switch on all units. Press and hold
MAIN VOLUME
for a second to switch on the Model:Cycles.