Elektron Analog Four MKII, User Manual

Page: 14 / 108

3. PANEL LAYOUT AND CONNECTORS
14
7. MIDI IN, MIDI data input. Use a standard MIDI cable to connect to MIDI Out of an external MIDI device.
8. CV OUTPUTS A–D, Connect to external synth with CV inputs. Use standard 1/4” mono phone plug.
9. AUDIO INPUT L/R, Use standard 1/4” mono phone plug to input sound from other synthesizers or mixers.
10. TRACK 1–4 STEREO OUTPUTS, Use standard 1/4” stereo (Tip/Ring/Sleeve) phone plug or 1/4” mono
phone plug.
11. MAIN OUT L/R , Use either 1/4” mono phone plug (unbalanced connection) or 1/4” stereo (Tip/Ring/
Sleeve) phone plug (balanced connection).
12.
HEADPHONES.
Audio output for stereo headphones. Use 1/4” (Tip/Ring/Sleeve) phone plug.
Use the included PSU-3b with your Analog Four MKII. It can, using an appropriate power
cord, be used all over the globe without the need of voltage converters. Using the wrong type
of adapter may damage your unit. Damage caused by the use of incorrect power supply is
not covered by warranty. For more information, please see “17. TECHNICAL INFORMATION”
on page 80.
3.3 CONNECTING THE UNIT
Make sure you place the Analog Four MKII on a stable support, such as a sturdy table with sufficient cable
space, or mount in a rack according to the instructions above. Before you start connecting the Analog Four
MKII to other units, make sure all units are switched off.
1. Plug the supplied DC adapter to a power outlet and connect the small plug to the DC IN connector of the
Analog Four MKII unit.
2. Connect the main out L/R from the Analog Four MKII to your mixer or amplifier.
3. If you want to use MIDI, connect MIDI OUT from the Analog Four MKII to the MIDI IN of the device you
wish to send data to. Connect the MIDI IN of the Analog Four MKII to the MIDI OUT of the device you
wish to receive data from. The MIDI THRU port “echoes” the data arriving at the MIDI IN port, and is used
for chaining MIDI units together.
4. Switch on all units. Switch on the Analog Four MKII by pressing the Power switch located at the back of
the unit. Before restarting the unit, wait 2 seconds after the screen goes out.