© 2018 Electromedical Technologies, Inc. Phoenix, AZ USA. Any use of editorial, pictorial or layout composition of this publication without express written consent from Electromedical Technologies,
Inc. is strictly prohibited. This publication was written, illustrated and prepared for print by Electromedical Technologies, Inc
37
Step 18: Enter desired running time for this frequency by pressing numbers 1 through 60.
Step 19: Press
button
Step 20: Enter desired wave type by pressing numbers 1 through 5.
Step 21: Finish programming
For this step you have 2 options:
Option #1:
Pressing
CODE
will complete your programming procedure. You will see the message “Completed!”
followed by “Ready” message.
Option #2:
Pressing
START
instead of the CODE button will complete your programming procedure and start
your custom code.
NOTE:
To use your custom frequencies without storing the frequencies in the memory of the unit, skip steps 1
and 2 described in this chapter.
Mistakes & Errors
If you use the incorrect order to enter your data, the unit will sound ("squeak") alerting you to the error.
When you hear this noise, read the instructions carefully, press CLEAR, and correct your mistake. To
minimize these errors, we have implemented the display interface that will guide the user during
programming sequences.
If you give the unit an incorrect number or code, the display will read NOT VALID NUMBER. You will
need to re-enter a number that actually exist in the memory of the unit.
If the unit freezes, unplug the unit, wait a few seconds, then plug it in and turn it on.
