Electrolux SPEEDELIGHT, Original Instructions Manual

Page: 31 / 38

31
4. Help the descent of the upper heating plate by guiding the
flexible tube (C).
5. The upper heating plate has to stand upright on the glass
protection. You can see clearly the baking paper clips on
the top of the upper heating plate.
6. Remove the old baking paper, if present.
7. Fix the new baking paper by engaging its two sides under
the clips.
8. Put the upper heating plate in the original position. Guide
the flexible tube to avoid any damages.
Respect the right position of the upper heating plate. The
symbols “FRONT“ must be as in the picture.
IIM MP PO OR RT TA AN NT T
• Do not lift the clips.
• Strength the paper to avoid stripes.
• Make sure that the baking paper covers
all the surface of the upper heating
plate.
Install the baking paper on the glass (optional)
1. Clean the glass (refer to “L.5 Daily cleaning“).
2. Lay the baking paper on the glass.
It must cover only the glass surface, do not exceed over the
glass surface.
K K T TR RO OU UB BL LE ES SH HO OO OT TIIN NG G
K K..1 1 R Re em me ed diie ess ffo orr a ap pp plliia an ncce e m ma allffu un nccttiio on niin ng g
If the appliance does not start or stops during operation, first try to find a solution to the problem (refer to the table below). If not,
contact the after-sales service.
With some problems, you can heard some acoustic signals and the display shows an error massage.
P Prro ob blle em mss S So ollu uttiio on n IIff tth he e p prro ob blle em mss rre em ma aiin nss
The appliance does not switch on. Verify if the appliance is plugged in the
socket and/or the circuit breaker is on.
The lid doesn’t keep closed when you are
in operating mode. Check if the handle and the counter part
of the appliance are properly cleaned. Call the service.
The appliance shuts off unexpectedly.
-
Call the service.
The display of the appliance does not
show anything and buttons light are
blinking. The appliance is in standby mode.
To exit from standby, press any buttons. Call the service.
The display of the appliance shows error
messages. Switch off and switch on the appliance. Call the service.
The lid doesn’t open and the display
shows the symbol with the triangle.
-
Call the service.
Warning: Carefully move the lid.
The Microwave does not work. Can use programs without the
microwave. Call the service.
C CA AU UT TIIO ON N
If the problem persists, switch off the equipment, unplug power cable and make sure that nobody
can use the appliance.