9
ENGLISH
• The electrical outlet should be readily
accessible so that the unit can be
unplugged easily in an emergency. Or
it should be possible to isolate the oven
from the supply by incorporating a
switch in the fixed wiring in accordance
with the wiring rules.
• The power supply cord may only be
replaced by an electrician.
• If the supply cord is damaged it must
be replaced by the manufacturer, its
service agent or similarly qualified
persons in order to avoid a hazard.
• The socket should not be positioned
behind the cupboard.
• The best position is above the
cupboard, see (A).
• Connect the appliance to a single
phase 220-240 V/50 Hz alternating
current via a correctly rated earth
socket.
• If the appliance is to be operated in a
non-European country, the supply
voltage, current type and frequency of
the appliance indicated on the rating
plate must correspond with the
specification of your power supply. The
rating plate can be found on the inside
face of the control panel.
• Before installing, tie a piece of string to
the power supply cord to facilitate
connection to point (A) when the
appliance is being installed.
• When inserting the appliance into the
high-sided cupboard, DO NOT crush
the power supply cord.
• Do not immerse the power supply cord
or plug in water or any other liquid.
• Do not allow the power supply cord to
run over any hot or sharp surfaces,
such as the hot air vent area at the top
rear of the oven.
2.2
Connecting the appliance to
the power supply
(A)
1_ELECTROLUX_EN240_MG_BASE_AJ26UICTO_SAFETYMAY19_Layout 1 24/10/2018 12:42 Page 9
