8.
INSTALLATION
WARNING!
Refer to Safety chapters.
8.1
Hob and oven connection
type
This appliance has a blue 1x14 pole and
red 1x14 pole connector and can be
connected to an oven with a blue 1x14
pole and red 1x14 pole connector.
8.2
Before the installation
Before you install the hob, write down the
information bellow from the rating plate.
The rating plate is on the bottom of the
hob.
Model .......................................
PNC .........................................
Serial number ...........................
8.3
Built-in hobs
Only use the built-in hobs after you
assemble the hob into correct built-in units
and work surfaces that align to the
standards.
8.4
Attaching the seal
1.
Clean the worktop around the cut out
area.
2.
Attach the supplied seal stripe to the
lower edge of the hob along the outer
edge of the glass ceramic. Do not
extend it. Make sure that the ends of
the seal stripe are located in the
middle of one side of the hob.
3.
Add some mm when you cut the seal
stripe to the length.
4.
Push the two ends of seal stripe
together.
8.5
Building In
min.
50mm
min.
500mm
490
+1
mm
min.
55mm
4x
Ø10
560
+1
mm
min.
25 mm
www.electrolux.com
44
Summary of Contents for KM412.2
Page 47: ...ENGLISH 47 ...
