Electrolux FMB330RGB0, Service Manual

Page: 11 / 27

11
Always turn off the power supply before servicing any
electrical component, making ohm meter checks, or
replacing any part.
All voltage checks should be made with a voltmeter having
a full scale range of 130 volts or higher.
After service is completed, be sure all safety grounding
circuits are completed, all electrical connections are
secure and all access panels are in place.
Outer Door Panel
1. Outer door panel mounts onto inner door panel with
six screws, three on each side
2. While holding outer door panel in place remove the
bottom three screws from both sides of inner door
panel.
DISASSEMBLY AND SERVICE
Six door panel
screws
Vent
Dispenser
Console
1. Disconnect power to the dishwasher.
2. Remove outer door panel
3. Remove six screws holding console to the inner
door panel. Leave the center two screws on either
side of the door latch until last.
Timer
1. Disconnect power to the dishwasher
2. Remove outer door panel
3. Remove knob from timer by pulling straight off
timer shaft
4. Remove console
5. Press in on locks for the disconnect block and pull
block from timer.
6. Remove two timer mounting screws. Ground
wire has a locking terminal press down on lock to
remove terminal.
Door Latch
1. Disconnect power to the dishwasher
2. Remove console from inner door panel
3. Remove two screws mounting door latch to
console.
4. Remove four wires from latch. Terminals have locks,
press down on lock to remove terminal.
Selector Switch
1. Disconnect power to the dishwasher
2. Remove console from inner door panel
3. Remove two screws mounting selector switch from
console
4. Remove four wires from selector switch. Terminals
have locks press down on lock to remove terminal.
IMpoRTANT NoTE
All terminals on this
dishwasher are locking
terminals and have a
release that needs to
be pressed down to
remove wires from all
electrical components.
Selector Switch
Door Latch
Timer