Technical Support - DMM
32/106
599 77 23-65 Rev. 03
6
“DEMO” MODE
A special cycle is designed to demonstrate the operation of these appliances in shops, without connecting them
to the water mains. This way, any one of the programmes can be selected and, once the start button/sensor has
been pressed/touched (START/PAUSE), the appliance will only perform some of the phases of the programme,
skipping those which cannot be performed (water fill, drain, heating).
The cycle takes place as follows:
The door lock is enabled regularly (door locked during operation, possibility of opening it at the end of the
cycle or when paused).
Motor: all low speed movements are enabled, the pulses and spin are disabled.
The water fill solenoid valves and the drain pump are disabled.
Display: as the cycle phases are very fast (one second in the demo cycle corresponds to approximately
one minute in the actual cycle) the end time decreases by 1 unit per second. Bear in mind that the end time
does not always correspond to the actual cycle time.
6.1 Access to DEMO settings
The operations listed below must be carried out within 7 seconds.
SERIES 7
SERIES 8
SERIES 9
Do not start the procedure with the buttons in the combination pressed
1. Switch on the appliance using the ON/OFF button.
2. Turn the selector dial until the third LED in the right-hand row is on.
3. Press the
START/PAUSE
button and the nearest
option
button
simultaneously (as shown in the figure).
4. Hold the buttons down (approximately three or five seconds) until
“dEM” flashes for a short time.
6.2 Exiting DEMO mode
To quit the demo mode, unplug the appliance at the socket, because the ON/OFF button does not function.
