Technical Support - DMM
19/106
599 77 23-65 Rev. 03
4.2.1.4
Pushbuttons
– LEDs and LCD
The functions of each button are defined by the configuration of the appliance.
Button no. 1
: ON/OFF
Description: see
Button no. 1
on page 11
Button no. 2
: TEMPERATURE
See description on page 11
The only difference with version 7 is the representation of the cold
cycle, which is represented by the cold symbol and by two
dashes
“
“ to replace the Digits.
Button no. 3
: SPIN SPEED
This is related to the part of the LCD display in which the washing
cycle spin speed is shown.
The spin speed displayed initially is that configured for the chosen
programme.
Press the button in sequence to lower the speed. Once the lowest
speed has been reached, the next one is
“Rinse Hold” and the
related light up (if compatible with the programme selected).
This is also lit during the
“Extra silent” programme.
The next selection will be the highest speed available for the
programme.
The spin speeds are:
1,600
–1,400–1,200–1,000–800–600–400– “Rinse Hold” cycle.
When no speed is selected, or the
“Rinse Hold” cycle is selected,
the LCD display shows three dashes
“
- - -
“.
The settings described below not only have symbols, but they are also accompanied by a graphic bar within a
frame. If it is illuminated, this indicates that the option is enabled for the chosen programme, otherwise it is off.
When all its segments are lit, it will start from scratch again the next time it is pressed.
Button no. 4
: OPTION
It is related to the part of the LCD display (see figure) where the
graphic bar and the symbols relating to the options are displayed,
depending on the chosen programme.
Press the button to light the graduated scale and the Stains
symbol lights simultaneously. If you continue to press it, the
Prewash symbol also lights up.
The selection order is as follows:
1.
Stains
2.
Pre-wash
3.
Prewash
Button no. 5
: OPTION
It is related to the part of the LCD display (see figure) showing:
the graphic bar, a digit and the
“Extra rinse” symbol.
Press the button to light the graduated scale. The symbol for the
“Extra rinse” lights simultaneously, and the digit shows the
number of additional rinses to combine with the programme.
The number of rinses depends on the programme configuration.
