Electrolux EWW8025DGWA, User Manual

Page: 20 / 84

20 www.electrolux.com
When the program is completed and
the door lock indicator “ ” goes off,
you can open the door.
(Option “Rinse Hold” is used)
The drum turns regularly to prevent
the creases in the laundry.
You must drain the water to open the
door.
The indicator “Start/Pause ” flashes
to remind you to drain the water.
-
-
-
The appliance stops automatically.
The acoustic signal will operate.
The display will show “ ”.
The indicator of the touchpad
“Start/Pause ” goes off.
-
-
-
-
-
-
-
-
The door lock indicator “ ” goes off.
Remove the laundry from the
appliance. Make sure that the drum is
empty.
Keep the door partly open, to prevent
the mildew and odours.
Turn off the water tap.
At the end of the program, the time
remaining can suddenly decrease
from 7 minutes or less to 0 due to the
overestimated total program time
during the load sensing phase. In
some cases (with perfectly balanced
load) the program time can be shorter
than the time estimated after the load
sensing phase is completed. This is a
normal behavior of the machine and
not a cause for concern as it does not
compromise its performance.
NOTE:
The door lock indicator “ ” is on.
The door stays locked.
1.
To drain the water:
Press the “Start/Pause ” touchpad.
The appliance drains the water and
spins with the maximum spin speed
for selected program.
Alternatively , before pressing the
“Start/Pause ” touchpad, you can
press the “Spin ” touchpad to
change the spin speed. You can
select “No Spin ”, if you want the
machine to only drain the water.
2.
turn the program selector knob to the
position “Off” to deactivate the
appliance.
3.
After approximately 18 hours, if you
do not press Start/Pause touchpad,
the appliance will drain and spin
automatically.
All indicators and the display will
switch off.
The indicator of the touchpad
“Start/Pause ” will flash slowly.
Press any touchpad to reactivate
the appliance.
The AUTO Standby mode automatically
deactivates the appliance to decrease
the energy consumption when:
You do not press any buttons for
5 minutes before you press
“Start/Pause ”.
5 minutes after the washing program
ends, if you do not deactivate the
appliance, the energy saving function
activates.
Press any touchpad to
reactivate the appliance.
-
-
All indicators and the display will
switch off.
The indicator of the touchpad
“Start/Pause ” will flash slowly.
-
-
Press any touchpad again to show
the last wash program.
Turn the selector knob to set a new
wash program.
-
-
-
Display will show the end of the last
wash.
Press “Start/Pause ” to start the
program.
5.9 At The End Of The Program
5.11 AUTO Standby Function
5.10 When The Washing
Program Is Completed, But
There Is Water In The Drum