23
C45Q001
Installation
Removing the transit bolts
Parts used to protect the internal components of
the appliance during transport must be removed
before the appliance is used for the first time.
These parts and their mountings must be kept for
future transport.
1. Remove the packaging from the appliance. Tilt the
appliance towards the rear, rotate it through a quarter
of a turn on one of the rear corners to remove the
transport pallet.
This comes away naturally from the appliance.
2. Open the lid of the appliance and remove the wedge
which is blocking the drum and the red plastic
spacer. Close the lid.
3. On the rear part and using a 10 mm spanner, unscrew
and remove the red spacers (A).
4. The holes which are now visible should be blanked
with the plugs (B) which are located in the bag
attached to the appliance, remembering to insert the
central capsule.
5. Ensure that you have removed all these parts from
the appliance and keep them for future transportation
(e.g. when moving house).
6. If you want to align your appliance with neighbouring
furniture, you can cut the pipe bracket located on the
rear of the appliance. This will gain an extra 2 - 3 cm
in depth. Leave the two side blanks in place.
Location
Place the appliance on a flat and solid floor.
Ensure that the appliance is not touching the wall or other
cabinets in the kitchen.
The tap, the drain pipe and the power socket must be
located near to the machine’s pipes and the power lead.
To install your appliance, you need:
a power supply (see electrical connection),
a water inlet with a 20 x 27 mm connection,
a drain with a minimum height of 70 cm,
a ventilated room.
B
A
Summary of Contents for EWT 1058
Page 1: ...INSTRUCTIONS MANUAL EWT 1058 GB WASHINGMACHINE ...
Page 2: ...2 ...
Page 26: ...02 02 ...
