Problem
Possible cause
Solution
The compressor does not
start immediately after
pressing the FastFreeze
or after changing the tem‐
perature.
This is normal, no error
has occurred.
The compressor starts after
some time.
Water flows on the floor.
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
Attach the melting water out‐
let to the evaporative tray.
Temperature cannot be
set.
The FastFreeze or Shop‐
pingMode function is
switched on.
Switch off FastFreeze or
ShoppingMode manually, or
wait until the function resets
automatically to set the tem‐
perature. Refer to "Fast‐
Freeze or ShoppingMode
function".
The temperature in the
appliance is too low/too
high.
The temperature regulator
is not set correctly.
Set a higher/lower tempera‐
ture.
The food products tem‐
perature is too high.
Let the food products tem‐
perature decrease to room
temperature before storage.
The FastFreeze function
is switched on.
Refer to "FastFreeze func‐
tion".
Door does not open easi‐
ly.
You attempted to re-open
the door immediately after
closing.
Wait a few seconds between
closing and re-opening of the
door.
If the advice does not lead to
the desired result, contact
the nearest Authorised
Service Centre.
8. TECHNICAL DATA
8.1 Technical data
Height
1550 mm
Width
595 mm
Depth
668 mm
Voltage
230 - 240 V
Frequency
50 Hz
Rising time
11 h
The technical information is situated in
the rating plate, on the external or
internal side of the appliance and on the
energy label.
www.electrolux.com
10
Summary of Contents for EUF2047AOW
Page 35: ...УКРАЇНСЬКА 35 ...