Problem
Possible cause and solution
The interior of the appliance
is wet.
• This is not a defect of the appliance. it is caused by
the humidity in the air that condenses on the walls.
Unusual foam during wash-
ing.
• Use the detergent for dishwashers only.
• There is a leak in the rinse aid dispenser. Contact an
Authorised Service Centre.
Traces of rust on cutlery.
• There is too much salt in the water used for washing.
Refer to
"The water softener"
.
• Silver and stainless steel cutlery were placed togeth-
er. Avoid to put silver and stainless steel items close
together.
There are residues of deter-
gent in the dispenser at the
end of the programme.
• The detergent tablet got stuck in the dispenser and
therefore was not completely washed away by wa-
ter.
• Water cannot wash away the detergent from the dis-
penser. Make sure that the spray arm is not blocked
or clogged.
• Make sure that items in the baskets do not impede
the lid of the detergent dispenser from opening.
Odours inside the appliance.
• Refer to
"Internal cleaning"
.
Limescale deposits on the ta-
bleware, on the tub and on
the inside of the door.
• Refer to
"The water softener"
.
Dull, discoloured or chipped
tableware.
• Make sure that only dishwasher-safe items are
washed in the appliance.
• Load and unload the basket carefully. Refer to bas-
ket loading leaflet.
• Place delicate items in the upper basket.
Refer to
"Before first use"
,
"Daily use"
or
"Hints and
tips"
for other possible
causes.
13.
TECHNICAL INFORMATION
Dimensions
Width / height / depth
(mm)
596 / 818 - 898 / 575
Electrical connection
1)
Voltage (V)
220 - 240
Frequency (Hz)
50
Water supply pressure
Min. / max. bar (MPa)
0.5 (0.05) / 8 (0.8)
Water supply
Cold water or hot water
2)
max 60 °C
Capacity
Place settings
13
ENGLISH
21
Summary of Contents for ESI5510LAX
Page 67: ...TÜRKÇE 67 ...
