Electrolux ESI 47020, User Manual

Page: 21 / 28

Contact your local Service Force Centre,
quoting the model (Mod.), product number
(PNC) and serial number (S.N.).
This information can be found on the rating
plate located on the side of the dishwasher
door. So that you always have these numbers at
hand, we recommend you to make a note of
them here:
Mod. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PNC : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
S.N. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
The wash results are not satisfactory
The dishes are not
clean • The wrong programme has been selected.
• The dishes are arranged in such a way as to stop water reaching all parts
of a surface. The baskets must not be overloaded.
• The spray arms do not rotate freely due to incorrect arrangement of the
load.
• The filters in the base of the washing compartment are dirty or incorrectly
positioned.
• Too little or no detergent has been used.
• Where there are limescales deposits on the dishes; the salt container is
empty or incorrect level of the water softener has been set.
• The drain hose connection is not correct.
• The salt container cap is not properly closed.
The dishes are wet
and dull • Rinse aid was not used.
• The rinse aid dispenser is empty.
There are streaks,
milky spots or a blu-
ish coating on
glasses and dishes • Decrease rinse aid dosage.
Water drops have
dried onto glasses
and dishes • Increase rinse aid dosage.
• The detergent may be the cause. Contact the detergent manufacturer con-
sumer care line.
If after all these checks, the problem persists,
contact your local Service Force Centre.
Technical data
Dimensions Width cm 44,6
Height cm 81,8 - 89,8
Depth cm 57,5
Electrical connection - Voltage -
Overall power - Fuse Information on the electrical connection is given on the rating plate
on the inner edge of the dishwasher door.
Water supply pressure Minimum 0,05 MPa (0,5 bar)
Maximum 0,8 MPa (8 bar)
Capacity Place settings 9
Hints for test institutes
Testing in accordance with EN 60704 must
be carried out with appliance fully loaded and
using the test programme (refer to 'Washing
programmes').
Test in accordance with
EN 50242 must be
carried out when the salt container and rinse
aid dispenser have been filled with salt and
rinse aid respectively and using the test pro-
gramme (refer to 'Washing programmes').
electrolux 21