16
Drain / self-cleaning cycle
This button starts a drain/self-cleaning cycle. When the cycle is
selected, the button indicator is lit up.
G
COMMISSIONING
G.1
Preliminary checks, adjustments and
operational tests
WARNING
These operations must only be
carried out by specialized techni-
cians provided with adequate
personal protection equipment
(e. g. safety footwear, gloves,
glasses, etc.), tools and suitable
ancillary
equipment
with
the
appliance switched off and cold.
Electrical and plumbing checks
Before starting the machine:
• check correct connection of the electrical wires that feed the
machine;
• make sure the power supply voltage and frequency match
the data given in the technical data table (C.1
• check correct connection of the water supply and drain
pipes (see paragraph E.8
• make sure all the guards, safety devices and emergency
switches are in place and efficient.
Check the fitting of filters
• Make sure the filters “C“ - “D“ - “E“ are correctly fitted.
Check the fitting of wash and rinse arms
• Make sure the upper and lower wash and rinse arms are
correctly fitted.
G.2
Detergent/rinse aid dispensers and
prearrangements
If the machine is connected to a water softener and/or a
reverse osmosis system, contact the detergent supplier for a
specific product.
If the peristaltic dispensers are installed in the machine, the
dosage of detergent/rinse aid is done automatically according
to the desired concentration. The concentration of detergent/
rinse aid depends on the type of product used and the
hardness of the supply water (check the characteristics on the
product label).
CAUTION
The peristaltic dispensers (detergent and
rinse aid) and the tube inside the rinse aid
dispenser require periodical maintenance
(at least once or twice a year) or after
prolonged machine idle periods.
1.
Dishwasher with incorporated liquid detergent dis-
penser pump
Pump “R“ dispenses about 0.9 g/s of detergent. When the
appliance is filled with water for the first time in the day, it
dispenses about 46 g of detergent in 55 sec., thereby
providing a concentration of 2 g/l. Pump “R“ dispenses
about 4 g in 5 sec. at each cycle. Dispenser operating time
may be changed, following the instructions given in the
chapter H.2
. Insert the supplied
hose into the detergent container.
2.
Dishwashers with incorporated rinse-aid dispenser
pump
Pump “S“ dispenses about 0.1 g/s of rinse-aid. When the
appliance is filled with water for the first time in the day, it
dispenses about 1,2 g in 11 sec., thereby providing a
concentration of 0,1 g/l. Pump “S“ dispenses about 0,2 g
in 2 sec. at each rinse cycle. Dispenser operating time
may be changed, following the instructions given in the
chapter H.2
. Insert the supplied
hose into the rinse-aid container.
3.
Automatic dispenser arrangement for solid detergent
Inside the tank there is a hole “O“ (
⌀
22 mm), closed with a
plug, for introducing the detergent.
On the bottom of the tank there is an additional closed
hole “N“ (
⌀
22 mm) to be used for the installation of the
conductivity probe.
C
D
E
N
S
R
O
