• Use a male/female adapter (not
supplied) to install the nut and
the olive on the gas supply
ramp.
• Put the pipe into the gas sup-
ply ramp.
2.
Use a 22 mm spanner to tighten the
nuts.
Keep the gas supply ramp in the cor-
rect position. Do not apply force to
the gas supply circuit.
WARNING!
Do not use a flame to control
for leaks!
3.
Fully move the oven into the built-in
cabinet. Follow the instructions in
"Building-in the Appliance"
4.
Seal the connection correctly. Use a
leak detection to control it.
WARNING!
Do not squeeze the gas supply
ramp and the pipe when you
move the oven into the built-in
cabinet.
Warning: This appliance does not op-
erate with the gas settings as they
are. Before the gas connection, it is
important to adjust the injector(s) to
the correct type of gas. Refer to the
instructions in "Adjustment to differ-
ent types of gas".
13.3
Replacing the gas grill
burner injector
A
1.
Undo the two fixing screws (
A
) which
keep the oven gas burner in place
B
C
D
2.
Gently slide the gas grill burner off its
slot and slowly move it downwards.
Be careful not to cause stress to the
spark plug connection wire (
B
) and
the thermocouple (
D
) conductor.
3.
With a 7 mm socket spanner un-
screw and remove the gas grill burn-
er injector (
C
), and replace it with a
correct one (see "Gas Grill Burner
Data").
4.
Assemble the burner again. Follow
the procedure in reverse order.
The gas grill burner does not need
any primary gas regulation.
13.4
Adjustment to different
types of gas
WARNING!
Let only an authorized person do
the adjustment to different types
of gas.
This appliance is for operation
with natural gas.
With the correct injectors, you can
also operate it with liquid gas.
The gas rate is adjusted to suit.
Replacing the gas oven burner injec-
tor:
18 www.electrolux.com
