Remove a lime residue with water and
vinegar.
Caution!
Chemical de-scaling agents
can damage the oven enamel. Obey
instructions of the manufacturer!
Water drawer and steam generator
1. Fill the water and vinegar mixture (ap-
proximately 250 ml) through the water
drawer in the steam generator.
Let to operate for approximately 10 mi-
nutes.
2. Remove the water and vinegar with a
soft sponge.
3. Use clean water (100-200 ml) to flush
the steam generation system through
the water drawer.
4. Remove water from the steam genera-
tor with the sponge and rub dry.
5. Keep the door open to let the oven dry
fully.
Replacing the rear oven light bulb/cleaning
the glass cover
1. Turn the glass cover anti-clockwise to
remove it.
2. Remove seals and metal ring, and clean
the glass cover.
3. Replace the oven light bulb with appli-
cable 300°C heat-resistant oven light
bulb.
4. Fit seals and metal ring to the glass cov-
er.
5. Install the glass cover.
Replacing the oven lamp (left side of
the appliance)
Cleaning the glass cover
1. Remove the left shelf support rail.
2. Use a cross-tip screwdriver to remove
the glass cover.
3. Take off the metal frame and seal and
clean.
4. If necessary: Replace the oven lamp.
Technical data: 25 Watt, 230 V, heat re-
sistant.
5. Install metal frame and seal and tighten
screws.
6. Install the left shelf support rail.
Oven door and glass panels
To clean the oven door remove it.
Caution!
Be careful when you remove
the door from the appliance. The door
is heavy!
Removing the oven door
1. Open the oven door as far as it goes.
2. Lift up clamping levers (A) on the two
door hinges fully.
A
A
3. Close the oven door until the first posi-
tion (angle approximately 45°).
45°
4. Hold of the oven door with one hand on
each side and pull it away from the oven
at an upwards angle.
Put the oven door with the outer side
down on a soft and level surface to
prevent scratches
To install the door follow the procedure in
reverse.
electrolux
17
Summary of Contents for EOB98001
Page 1: ...user manual Oven EOB98001 ...
