Electrolux ENN2812BOW, User Manual

Page: 13 / 24

Problem Possible cause Solution
There is too much
frost. Food is not wrapped cor-
rectly. Wrap the food correctly.
The door is not closed
correctly. Refer to "Closing the door".
The temperature regulator
is not set correctly. Set a higher temperature.
6.1 Replacing the lamp
CAUTION!
Disconnect the plug from the
mains socket.
1
1
2
1. At the same time, with the fingers ex-
pand up and down the transparent cov-
er and unhook it in the direction of the
arrows.
2. Replace the lamp with one of the same
power and shape, specifically designed
for household appliances. (the maximum
power is shown on the light bulb cover).
3.
Reassemble the lamp cover.
4. Connect the plug to the mains socket.
5. Open the door. Make sure that the light
comes on.
6.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
7. INSTALLATION
WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
7.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Cli-
mate
class Ambient temperature
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
7.2 Electrical connection
Your appliance must be connected to a
single-phase supply of 230 V. Check that
the electricity meter is suitable for the
power consumed by your appliance, al-
lowing for the other connected applian-
ENGLISH 13