Electrolux EKD60750, User Manual

Page: 8 / 72

7
Adjusting the height of the base
If you wish to adjust the height, please read
the following points before you start.
1 Lay down the cooker gently
(
SEE ILLUSTRATION
) . Use, for example,
the polystyrene from the packaging
between the cooker and the floor as
protection. Remember to locate a
protective layer under the lower rear
corners of the cooker sides to protect
the floor.
2 Unscrew the screws A (4
SCREWS
,
SEE
ILLUSTRATION
) . Pull out the inner base
slightly if you only wish to change the
height. Pull the brackets on which the
wheels and feet are fitted.
NOTE! Be
careful, there are sharp edges under the
cooker.
3 Screw in the screws again A in one of
the holes for a bench height of 850 to
920 mm (33.4" to 36.2"). The distance
between the holes varies between
7 mm (0.28") and 14 mm (0.51")
(see illustration a)
.
4 Lift the cooker upright and connect it
up to the mains. Push the cooker back
into position and make sure that it is
absolutely level before fitting the
safety equipment.
Horizontal adjustment
The cooker must be level so that, for
example, fat spreads evenly in the frying pan.
Place a spirit level or a frying pan containing
water on the ceramic glass plate when you
want to check whether the cooker is level.
If necessary, from the front of the plinth,
you can adjust the cooker wheels and feet by
15 mm (0.6"). Use a screwdriver to adjust the
rear wheels and a Polygrip for the front feet.
A
A
A
A
A
14
7 7 14 14
14
920
850