![Electrolux EB3SL90KCN User Manual Download Page 34](http://html.mh-extra.com/html/electrolux/eb3sl90kcn/eb3sl90kcn_user-manual_96599034.webp)
Clean all accessories after each use and
let them dry. Use a soft cloth with warm
water and a cleaning agent.
Clean stubborn dirt with a special oven
cleaner.
If you have nonstick accessories, do not
clean them using aggressive agents,
sharp-edged objects or a dishwasher. It
can cause damage to the nonstick
coating.
Dry the oven when the cavity is wet after
usage.
12.2 Removing the shelf
supports
To clean the oven, remove the shelf
supports.
Lift the shelf support up and pull it out.
2
3
1
Install the shelf supports in the opposite
sequence.
12.3 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the
cavity.
CAUTION!
Always hold the halogen
lamp with a cloth to prevent
grease residue from burning
on the lamp.
The side lamp
1. Remove the left shelf support to get
access to the lamp.
2. Turn the lamp glass cover
counterclockwise to remove it.
3. Clean the glass cover.
4. If necessary, replace the lamp with
an applicable 300 °C, G9 heat-
resistant lamp.
5. Install the glass cover.
6. Install the left shelf support.
13. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
13.1 What to do if...
Problem
Possible cause
Remedy
You cannot activate or op‐
erate the oven.
The oven is not connected
to an electrical supply or it
is connected incorrectly.
Check if the oven is cor‐
rectly connected to the
electrical supply (refer to
the connection diagram if
available).
www.electrolux.com
34