Electrolux CIV60344, User Manual

Page: 18 / 40

Problem Possible cause Remedy
Hob²Hood does not work. You covered the control
panel.
Remove the object from
the control panel.
You use a very tall pot
which blocks the signal.
Use a smaller pot, change
the cooking zone or oper‐
ate the hood manually.
Automatic Heat Up does
not operate.
The zone is hot. Let the zone become suffi‐
ciently cool.
The highest heat setting is
set.
The highest heat setting
has the same power as the
function.
The heat setting changes
between two levels.
Power management oper‐
ates.
Refer to "Daily use".
The sensor fields become
hot.
The cookware is too large
or you put it too near to the
controls.
Put large cookware on the
rear zones, if possible.
There is no sound when
you touch the panel sensor
fields.
The sounds are deactiva‐
ted.
Activate the sounds. Refer
to "Daily use".
comes on.
Child Safety Device or
Lock operates.
Refer to "Daily use".
comes on.
There is no cookware on
the zone.
Put cookware on the zone.
The cookware is unsuita‐
ble.
Use suitable cookware.
Refer to "Hints and tips".
The diameter of the bottom
of the cookware is too
small for the zone.
Use cookware with correct
dimensions. Refer to
"Technical data".
and a number come on. There is an error in the
hob.
Deactivate the hob and ac‐
tivate it again after 30 sec‐
onds. If comes on
again, disconnect the hob
from the electrical supply.
After 30 seconds, connect
the hob again. If the prob‐
lem continues, speak to an
Authorised Service Centre.
You can hear a constant
beep noise.
The electrical connection is
incorrect.
Disconnect the hob from
the electrical supply. Ask a
qualified electrician to
check the installation.
www.electrolux.com 18