Electrolux AMANA ADW350RA 0 Series, Service Manual

Page: 22 / 86

Page 21
VENT VALVE
1. Disconnect the dishwasher from electrical supply.
2. Remove outer door panel.
3. Remove control panel.
4. Slide the vent valve upward to remove from the
actuator arm.
DETERGENT / RINSE AID DISPENSER
1. Disconnect dishwasher from electrical supply.
2. Remove outer door panel.
3. Disconnect wiring.
4. Remove six Phillips screws and carefully push
dispenser into tub.
INNER DOOR PANEL
1. To replace inner door panel, remove control
panel, door vent, dispenser and latch.
2. Remove two bolts (T-25 TORX
®
) from each
hinge and lift off.
3. Remove two bolts and nuts holding "C" arms to
inner door panel.
DOOR SEAL
1. To remove seal, lift one end and pull entire seal
out.
2. To replace or reinstall seal, center white mark on
back of seal into center top of seal recess and
press seal into place.
3. Go to bottom and form seal into seal recess
making the "L" in the tub. Repeat for remaining
side.
4. Push seal into recess in 5 places up one side to
center top. Repeat for remaining side.
5. Close door and let door set seal into recess.
VENT BLOWER
1. Remove the door vent assembly.
2. Remove the two (2) screws securing the top vent
piece.
3. Remove the four (4) screws securing the lower
vent to the blower motor.
DOOR LATCH ASSEMBLY
1. Disconnect dishwasher from electrical supply.
2. Remove outer door panel.
3. The door latch is held to the inner door panel
with two screws and two locator pins. Remove
screws and pull to remove.
VENT ACTUATOR
1. Remove the door vent assembly..
2. Remove vent valve.
3. Remove two Phillips screws. Slide actuator from
vent housing.