Electrolux AMANA ADW350RA 0 Series, Service Manual, Page: 21 / 86

Page 20
DISASSEMBLY
SAFETY PRECAUTIONS
Always turn off the electric power supply before
servicing any electrical component, making ohmmeter
checks, or making any parts replacement. Refer to safe
servicing procedures at the front of this service manual
before servicing the dishwasher.
All voltage checks should be made with a voltmeter
having a full scale range of 130 volts or higher.
After service is completed, be sure all safety grounding
circuits are complete, all electrical connections are
secure, and all access panels are in place.
CONTROL PANEL - Mechanical Timer Models
1. Disconnect the dishwasher from electrical supply.
2. Remove six (6) Phillips screws from top of inner
door panel.
TIMER
1. Disconnect dishwasher from electrical supply.
2. Pull timer knob off of timer shaft.
3. Remove control panel.
4. Remove two Phillips screws securing timer to control
panel.
.
4. Unplug wiring harness plug connector to test or
replace timer.
5. When replacing timer, be sure to transfer protective
plastic covering to new timer.
DISASSEMBLY TIP
When removing the timer knob, slide a lightweight
handerchief between the timer knob and the control
housing. Then work the handkerchief all the way around
the backside of the knob. Then pull on the handkerchief,
pulling the knob off from the rear.
SELECTOR SWITCH
1. Disconnect the dishwasher from electrical supply.
2. Remove control panel.
3. Remove two Phillips screws, one on each end and
lift off switch.
DOOR PANELS - All Models
1. Disconnect dishwasher from electrical supply.
2. The outer door panel is held to the inner door panel
with two locking tabs and two screws. Loosen two
lower screws securing control panel.
3. Remove two screws securing door panel to door
(located at the lower section of the inner door
panel).
4. Slide door panel down and outward to remove.
DOOR VENT ASSEMBLY
1. Disconnect dishwasher from electrical supply.
2. Remove outer door panel.
3. Remove control panel.
4. Disconnect wiring to blower motor and vent actuator.
5. Remove four Phillips screws securing vent to inner
door panel.