Technical Support - BSP
4/27
599 73 44-69
Rev. 00
1.
INTRODUCTION
1.1
PURPOSE OF THIS MANUAL
The purpose of this Manual is to provide information of new User Interface board OMEGA.
1.2
WARNINGS
All work with open appliances must be done with the mains supply disconnected.
The intervention on electrical equipment should only be performed by qualified
personnel.
Before working on a device, check the efficiency of the system housing through means of
appropriate equipment. As an example, refer to the indications described / illustrated in
the portal Electrolux Learning Gateway (
http://electrolux.edvantage.net
After intervention, carry out electrical safety tests and check the correct
operation of all safety devices.
In the case of manipulation / replacement of the PCB, use the ESD kit (Code 405 50 63-
95/4) to prevent electrostatic discharge damage the circuit board see SB No. 599 72 08-09
