14
User manual
5.1.1
Edit programs
In this menu it is possible to change settings for any selected program.
When activating this menu all available wash programs are listed.
For factory made programs it is however only possible to change the amount of chemicals.
Copy/duplicate a program by a long press. In the copy, all parameters can be changed. It is possible to copy a mod-
ule from one program and paste it into another.
Header module: General
The parameters that are valid for the whole wash program are set in the header module.
• Start pumps at
– Set the temperature at which dosing pumps should start in case “start at temperature” is selected in the wash module.
• Safe disinfection
– Set if validation of temperature and time is needed.
• Max load
– Set the maximum allowed load weight.
• Min load
– Set the minimum allowed load weight.
• Residual moisture*
– Use when washing garments that are humid when loaded into the machine Set the known residual moisture of the
load that is going to be weighed.
• Use calculated weight*
– Select if the dosing of chemicals and the water levels should be related to the calculated weight of dry load instead of
the measured load. (Mainly used for cleaning mops).
• Water reduction
– Select if water levels should be adjusted to the weight of the load.
* Tip: Wash programs for floor cleaning mops should start with pre rinse(s) followed by an extraction before the
weighing module. Run the program with dry, clean mops with known weight and abort the program after the extrac-
tion. Measure the weight of the damp mops and calculate the residual moisture. Select “Use calculated weight”.
Parameters in main wash, pre wash, rinse, pre rinse and soaking modules:
Temperature settings
• Filling with pre heating
– Set if the water shall be heated to max; “Filling max. temperature”, during the filling phase. Can be used to shorten the
total program time.
• Filling max. temperature
– Set the max water temperature during the filling phase. The temperature will be adjusted by opening and closing the
hot/cold water valves and/or turning on/off heating.
• Wash temperature
– Set the wash temperature between 10–95
℃
.
• Maintain temperature
– Set if the set wash temperature shall be maintained during the whole washing time. This is mainly used for thermal
disinfection.
Tip: In a main wash, following a pre wash, the “Filling max. temperature” can normally be set as high as the “Wash
temperature”.
Time settings
The times are set in hours/minutes/seconds.
• Filling
– Set the absorbing/wetting/soaking time. Time starts to count down when set level is reached. During this phase the
textile will absorb water and the water valves will open to refill up to the set level.
• Washing
– Set the washing time. Time starts to count down when set level and temperature conditions are fulfilled.
• Start washing timer at
– Select from a drop down list if the washing time should start counting down when the set level is reached or when the
set wash temperature is reached.
Tip: In a main wash, following a pre wash, the time in the filling phase can normally be shortened since the textile al-
ready has absorbed water in the pre wash.
Water level settings
• Level
– Select water level from the drop down list. The relationship between drum diameter and level in mm is not linear.
Therefore, there is a list of proven levels that are adapted to give the same results regardless of drum size.
• Smart filling
– Select smart filling to get the most accurate water level.
Note!
If smart filling is selected the drum rotation will be stopped at the end of the filling.
For water level settings, please refer to section
.
