Electrolux Professional 603877, Installation And Operating Manual, Page: 34 / 46

34
Choke cover cleaning
• Wipe the choke cover with a cloth and rinse using another
damp cloth. Ensure removal of any grease or food residue
to prevent early failure due to charring effect.
IMPORTANT
Pay attention not to dent, scratch, cut or other-
wise damage the choke cover, its surface and
the silicon around it: this will result in shorter life
span of the component. Use only soft wet clothes.
K.3.3.1 Choke cleaning
CAUTION
Do not use detergents or chemicals for
cleaning the choke.
IMPORTANT
• Clean the choke only with the supplied brushes.
• Use cut-resistant protective gloves.
10. Put a cloth-paper on the working top to protect it.
11. Use the brass bristle brush to remove any food
incrustations.
Clean the choke by carefully rubbing the brush in two
different directions, as shown in the figures.
12. Then, use the nylon bristle brush to remove cleaning
residues.
Ensure the complete removal of any grease or food
residual to prevent carbonization effect.
IMPORTANT
Do not deform the choke gills. In case of
deformation, suspend the use of the appliance
and contact the Customer Care Service.
13. Remove the cloth-paper from the working top.
K.3.4 Cooking chamber
14. Push the upper plate to the highest point until it locks.
15. Clean the cooking chamber with a damp cloth.
16. Finally remove dirt and food residues from the rear slot
between the working top and the lid by sliding the paper.
K.3.5 Food tray cleaning
The tray coating material is easily cleaned but the tray life is
greatly determined by its handling and care.
Refer to the instructions enclosed with the tray.
17. Wipe the tray with a damp soft cotton cloth (or dish towel),
neutral detergent and warm water.
Do not use scrubbing pads, scrapers or any hard brushes
to remove the grease and burned deposit.
18. Shake off the excess of water and lay flat to dry.
Do not submerge or soak the tray in water.
CAUTION
Do not place the tray in dishwashers.
Never cut or use sharp metallic tools on
the tray surface.
Never scrape the special tray coating off
of the substrate.
Do not fold the tray.
2
2
1
1
2