Electrolux Professional 603877, Installation And Operating Manual, Page: 30 / 46

30
I.5.16 IMAGE MENU SETTING
1 2
3 4 DISPLAY IMAGE MENU
In this mode the program numbers are replaced by
IMAGES that can be uploaded in the appliance from an
USB key.
To upload the IMAGES:
1. Switch the appliance OFF.
2. Insert the USB key with the IMAGES file.
3. Switch the appliance ON.
Create the IMAGES file with the special program “Menu
Icons Editor” in the area “My Professional” at the following
WEB site:
https://electroluxprofessional.com (to enter this site you
need to register).
I.5.17 CONNECTIVITY SETTING
1 2
This function allows to connect the appliance to the Service
remotely. The Service will be able to check any errors that
may arise in the appliance.
For this function, see the steps described in the I.4.11
CONNECTIVITY paragraph in I.4 Basic settings chapter.
I.5.18 RECIPES MANAGEMENT FROM CLOUD (if
available in your model)
This function allows to receive/send recipes from/to cloud
once the appliance is connected remotely.
1 2
3 4
Press ON to activate this
function: the appliance is
ready to send and/or
receive the recipes to/from
cloud.
Press OFF to disable the
function. The appliance will
refuse any recipe update.
5
This pop up informs that
some recipes have been
updated remotely. Press
button “7“ or “8“ to confirm.
There is no possibility to
refuse the update.
I.6 Daily use
CAUTION
Starting a cycle without a sandwich can
cause malfunction and damage to the
appliance.
WARNING
Risk of burning. The glass and
the upper heating plate are hot.
1. Place the sandwich on the glass or on the tray making
sure that the sandwich/tray is fully under the upper heating
plate.
2. Close firmly the lid.
3. Press one of the “8“ program buttons to set the required
cycle.
4. At the end of the program, you can hear an acoustic
signal:
• The display shows a message about lid opening.
• The lid opens automatically.
5. Remove the sandwich from the glass or the tray by means
of the delivered plastic spatula (ANC 653625) or similar
tool.
IMPORTANT
With intensive use of high microwave cycles the
appliance may overheat and the symbols and
could appear: leave the lid open, remove the
tray and wait a few minutes for the screen with
programs to reappear on the display.
NOTE!
To interrupt the cycle press the buttons “7“ and “8“
or open the lid within 9 seconds after the program
start.
To restart the appliance again close the lid and
select a program again.
3x
3x
x4
OFF
ON