Electrolux Professional 588094, Installation And Operating Manual

Page: 21 / 34

21
G.4 Installing on feet or plinth
G.4.1 Installation
To transport the appliance to the final location, see E TRANSPORT, HANDLING AND STORAGE .
Packaging should only be removed immediately before the unit is installed. To do so, take away all side and top parts of the
packaging in turn, as well as the fixing elements.
The unit remains on the transport pallet until it is at its final location.
G.4.2 Positioning on concrete plinth
1. Transport the appliance on its transport pallet directly in
front of the point of installation.
2. Remove the pre-cut plate at the bottom of the appliance.
(for access, see F
Installation DIAGRAMS ).
3. Lift the unit on one side so that all installation connections
are inside the appliance.
4. Carefully lower the appliance and then move it into the
correct position. Finally, remove the transport palette.
5. Remove the outer protective film and the edge covers,
taking care not to scratch the surface of the appliance.
Very slowly pull off the protective film on the stainless steel
surfaces, without ripping, to prevent any adhesive residue.
Remove any adhesive residue with a non-corrosive solvent.
Then rinse and dry the spot thoroughly.
G.4.3 Positioning on steel plinth or adjustable feet
NOTE!
If installing on a steel plinth or adjustable feet, always make sure these are attached to the appliance beforehand.
There are no tools for taking the unit down from the transport pallet and putting it in place; all you need is manpower,
with two to four men required depending on the size of the unit.
1. Transport the appliance on its pallet to directly in front of
the point of installation. The installation connections that
are sticking out of the floor should be as close as possible
to the side of the transport pallet.
2. Remove the pre-cut plate at the bottom of the appliance.
(for access, see F
Installation DIAGRAMS ).
3. Shift the appliance onto the transport pallet such that all of
the installation connections lie within the appliance.
4. Tip the appliance until it is standing on the floor. Then lift at
the front and remove the transport pallet.