FCC COMPLIANCE
Note:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help
.
Modifications not expressly approved by the manufacturer could void the user's
authority to operate the equipment under FCC rules.
MICRO POG
Polyphonic Octave Generator
Congratulations on your purchase of the XO MICRO POG Polyphonic Octave
Generator. What does that mean exactly? Well, the MICRO POG can
simultaneously generate multiple octaves from your input signal. Whether
you play single notes, arpeggios or full chords, the MICRO POG will track,
every note or chord that you play, with precision. With the MICRO POG, you
can mix together your original "dry signal" with two different octaves (one
above and one below your original note) to create totally new inspiring
tones.
-CONTROLS-
DRY Knob
– Controls the output volume of the DRY signal. The DRY signal
is the signal present at the INPUT jack. As this knob is turned clockwise, the
volume of the DRY signal will increase.
SUB OCTAVE Knob
– Controls the output volume of the SUB OCTAVE
signal. The SUB OCTAVE signal is one octave below the original input signal,
half the frequency of the input signal. As this knob is rotated clockwise, the
volume of the SUB OCTAVE signal will increase.
OCTAVE UP Knob
– Controls the output volume of the OCTAVE UP signal.
The UP OCTAVE signal is one octave above the original input signal or twice
the frequency of the original input signal. The volume of the UP OCTAVE
signal will increase as this knob is rotated clockwise.
STATUS LED
– This LED indicates the current state of the unit. When the
LED is lit up, the box is in EFFECT mode. When the LED is off, the box is in
BYPASS mode. Pressing the Footswitch will toggle between effect and
bypass modes.
INPUT Jack
– This ¼” jack is the audio input to the POG. The input
impedance presented at the Input Jack is 2 M
Ω
.
WARNING: Use only the 9.6VDC/200mA AC
adapter the Micro POG
comes supplied with. Do not use any other AC adapters. Using other AC
adapters, even those made by Electro-Harmonix, could cause harm to the
unit, the adapter or you. The Micro POG does not use batteries.
